tommy2k10 Posted January 10, 2012 Share Posted January 10, 2012 I am troubleshooting a laptop for my friend. One of my eliminations is Defragging. Before I run the Defrag, I always Analyse. However, when I first start Defraggler, it says DISK HEALTH: ERRORS (see screenshot) When I run the Disk Benchmark, after analysis, it says there are no major errors on the disk. The Seagate disk test runs fine! I have taken a screenshot of the Health tab as well. Link to comment Share on other sites More sharing options...
Winapp2.ini Posted January 10, 2012 Share Posted January 10, 2012 Have you run a check disk yet? winapp2.ini additions thread winapp2.ini github Link to comment Share on other sites More sharing options...
tommy2k10 Posted January 11, 2012 Author Share Posted January 11, 2012 Yes I have, it says it found and repaired some errors, but I am still getting a Disk Health warning from Defraggler! Link to comment Share on other sites More sharing options...
bkcoca1 Posted September 29, 2016 Share Posted September 29, 2016 I have the same problem. There are no instructions about what is the cause or what is the solutio.dn to the ERROR. Any help is appreciated. bkcoca1 Link to comment Share on other sites More sharing options...
Willy2 Posted September 29, 2016 Share Posted September 29, 2016 - Run Piriform's SPECCY program. Choose "File" >> "Publish Snapshot" and post the link that pops up in your next reply. Perhaps your HD is in the first stage of failing. System setup: http://speccy.piriform.com/results/gcNzIPEjEb0B2khOOBVCHPc A discussion always stimulates the braincells !!! Link to comment Share on other sites More sharing options...
kevin2184 Posted May 24, 2017 Share Posted May 24, 2017 I also am getting the "Disk Health: ERROR" warning in Defraggler. If I "Analyze" and then "Optimize", the Defraggler seems to work but it doesn't seem to do anything (my fragmentation remains at 25%). I ran check disk which also seemed not to do anything, and then ran Defraggler again, but Here is my "snapshot" from Speccy: http://speccy.piriform.com/results/X7DnfLhvhEOSe6UuE8SaQQv (note my "Status" under "S.M.A.R.T." is ominously listed as "Bad".) I appreciate any insight here. Thanks. Link to comment Share on other sites More sharing options...
Willy2 Posted May 25, 2017 Share Posted May 25, 2017 - About SMART values: https://en.wikipedia.org/wiki/S.M.A.R.T. @kevin: Some "critical" attributes (&B8, &BB) have high values. And the "Wear Out Indicator" is also very high. Run SSD Life on your system. It's better suited for SSDs. https://ssd-life.com/ System setup: http://speccy.piriform.com/results/gcNzIPEjEb0B2khOOBVCHPc A discussion always stimulates the braincells !!! Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now