wcoppola
Oct 6 2008, 02:34 PM
hi,
I just upgraded to v1.03 and found that it does not show any drives at all. I have had to go back to version 1.2
I am using a Dell PC which has a serial ATA drive. Is this a controller issue.
Anyone else seen this or have suggestions?
W
wcoppola
Oct 7 2008, 09:17 AM
I can confirm this is a repeatable problem. I have tried v1.03 on my home Dell machine (which uses a SATA Raid controller, not in RAID mode) and no hard drives show up on this either.
Could someone look into this/ v1.02 works fine
Will