1 reply to this topic

[wcoppola]

hi,

I just upgraded to v1.03 and found that it does not show any drives at all. I have had to go back to version 1.2

I am using a Dell PC which has a serial ATA drive. Is this a controller issue.

Anyone else seen this or have suggestions?

W

[wcoppola]

I can confirm this is a repeatable problem. I have tried v1.03 on my home Dell machine (which uses a SATA Raid controller, not in RAID mode) and no hard drives show up on this either.

Could someone look into this/ v1.02 works fine

Will