Jump to content

Recuva Pro drive select dropdown flashes


jgt1942

Recommended Posts

I just installed Recuva Pro v1.52.1086, when I click on the drive select dropdown after about 2 seconds it starts to flash. This is super annoying.

 

In the dropdown I see most of the attached harddrives and under the disks I see

  • Recovery..... What is this?
  • Then it has a section labeled Local disk (\\.\HarddiskVolume xx) where XX is a number. How do I map these entries to the actual drives? (see the following image)
  • What are the shadow copies?
  • In Recuva I pressed the F1 key but no help is presented.

post-70695-0-41212800-1455231587_thumb.png

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.